Archer MR600 Antenna
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi
ive just got the new Archer MR600 4G router but seem to have strange behaviour when plugging in external antennas.
When i use the supplied antennas I get an ok signal so I thought I would try an external antenna. I’ve tried both a directional and an omni-directional antenna but both lower the signal?
Is there a setting on the router to state you are using a different antenna?
cheers
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@b15 hi it's this one.
Eightwood 4G Antenna 35dbi SMA Male Adapter Omni Directional Antenna 2m 6.5ft Cable + 2pcs SMA Jack Female to TS9 Plug Male Adapter for 4G LTE Router 2G 3G 4G GSM WLAN Bluetooth HSDPA UMTS DCS https://www.amazon.co.uk/dp/B07Y1N9ZTF/ref=cm_sw_r_cp_api_i_F3uXEbSWQRHDZ
- Copy Link
- Report Inappropriate Content
I have just purchased the antenna mentioned above.
I am in near perfect location, direct line of site to mast, about 1 to 1.5km away.
Had the modem in the window, and literally replaced it with new antenna and put the modem in a tucked away corner.
I took a grab of before and after for people to see.
But IMO it works great, cheapish, does the job I wanted it for of not needing the modem in the window. Signal boost - I'd be hard pushed to say it's any different though.
- Copy Link
- Report Inappropriate Content
can we use sma male splitter to connect to the router ?
How do we handle antennas which provide single sma male connections ?
- Copy Link
- Report Inappropriate Content
@Kevin_Z Hi i have tried with external antenna for MR600.. Initially i had doubt that this router supports or not but it supports 12dBi/24dBi external antenna.
You can check my setup using Archer MR600 in the following link.Hope it helps ..Cheers :)
- Copy Link
- Report Inappropriate Content
@SE-Fredd HI . Initially i also had some doubt on external antenna.. But i took a chance and that finally worked.. You can check the Mr600 with external antenna setup in my video..Hope it helps
- Copy Link
- Report Inappropriate Content
@sunchaser Hi .. Yes this supports external antenna. Hope the following link helps to solve your problem..
And hope TPlink will be thankful to me for taking a chance like buying MR600 for a remote area as i shown in video :)
- Copy Link
- Report Inappropriate Content
@Kevin_Z I have taken a chance to test MR600 with long cables and externa High gain antennas in a remote area,
You can check the complete setup and results in the following link.
Hope you can show this to your TPlink Tech team for refference..hope they appriciate it.
- Copy Link
- Report Inappropriate Content
Hello,
I have few questions regarding your setup
Question 1:- While connecting to the router you have not directly connected the cable to the SMA Female input. what is the conenctor you have used between cable to the router
Question 2:- what is the purpose of the 24dBi MIMO parabolic grid antenna. Have you connected this antenna with LPDA antennas
Question 3 :- Here is my plan to address my issue please let me know does this a correct approach
- 2 12dBi LPDA antenna with N female connector
- 2 20 meter 0.5 inch RF feeder cable N SMA Female to SMA Female
Question 4:- Where can get the beta software to update my Modem to change the band . Quick reply from you to help me to place the order
Please share your contact details to my email id cbzvenki@hotmail.com
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 5
Views: 54882
Replies: 45
Voters 2
