Archer VR200v: DHCP combined with VLAN id on WAN not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer VR200v: DHCP combined with VLAN id on WAN not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR200v: DHCP combined with VLAN id on WAN not working
Archer VR200v: DHCP combined with VLAN id on WAN not working
2019-09-06 13:24:21 - last edited 2019-09-09 03:06:36
Model: Archer VR300  
Hardware Version: V1
Firmware Version:

Hi all,

recently my provider changed the settings required to get an internet connection. I now need to set the VLAN id to 7.

 

After doing that, my internet connection works, but unfortunately my DHCP doesn't work. None of the clients have internet access. When assigning the same IP addresses statically on the client devices, everything is fine again.

 

How can I achieve dynamic IPs via DHCP again?

 

Kind Regards,

Ken

 

P.S.: My model is Archer VR200V - but it's not available for selection.

  0      
  0      
#1
Options

Information

Helpful: 0

Views: 661

Replies: 0