Forums

Stories

Knowledge Base

Home Network Community > Wi-Fi Routers > Access point?

< Wi-Fi Routers

Access point?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Access point?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Access point?

andrewh

LV1

2019-09-21 19:26:15 - last edited 2019-09-24 03:19:04

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-09-21

Access point?

2019-09-21 19:26:15 - last edited 2019-09-24 03:19:04

Model: Archer C60

Hardware Version:

Firmware Version:

I'd like to turn my AC1350 Archer C60 into an access point, but I can't see how to do it.

Any help much appreciated.

Thank you.

1 Accepted Solution

Kevin_Z

2019-09-23 06:40:37 - last edited 2019-09-24 03:19:04

Posts: 21207

Helpful: 4395

Solutions: 2502

Stories: 20

Registered: 2018-12-24

Re:Access point?-Solution

2019-09-23 06:40:37 - last edited 2019-09-24 03:19:04

@andrewh

If there is no operation mode option, you can configure the Archer C60 as an access point manually.

Please refer to the instruction below: https://www.tp-link.com/support/faq/1199/

Or you can watch the setup video, it contains the configuration method when there is no operation mode available.

https://www.tp-link.com/support/download/archer-c60/#video

May it help and have a good day.

TP-Link Annual Community Survey | Help Shape Our Community Throughout 2024!

Recommended Solution

7 Reply

SamuelV

LV1

2019-09-22 12:45:54

Posts: 13

Helpful: 4

Solutions: 0

Stories: 0

Registered: 2019-09-20

Re:Access point?

2019-09-22 12:45:54

Hello, Go to Settings \ Advanced \ Operation mode Hope this can help

andrewh

LV1

2019-09-22 15:41:19

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-09-21

Re:Access point?

2019-09-22 15:41:19

@SamuelV

Hi Samuel,

Thanks for the tip.

However this is what I also saw on a Youtube clip, but my system doesn't have 'Operation Mode' under Advanced Settings.

Any other suggestions?

Thanks,

Andrew

SamuelV

LV1

2019-09-22 15:51:52

Posts: 13

Helpful: 4

Solutions: 0

Stories: 0

Registered: 2019-09-20

Re:Access point?

2019-09-22 15:51:52

Hello Andrew. So may I suggest you to try the "quick and dirty old fashion" ? It is not guaranteed but could eventually work : unplug the ethernet cable from the WAN port and put it in one of the LAN ports of the C60. Then, power off the C60 and power it ON again. It could now act as an AP (it was the way we did with old TP-Link routers). I hope it will work for you. Just remember that you will have to access the C60 by its new IP address the main router will provide it.