Old networks

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Old networks

2019-12-08 12:48:21

Posts: 2

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2019-12-08

Old networks

2019-12-08 12:48:21

Model: Deco M9 Plus

Hardware Version: V20

Firmware Version: Latest

I deleted my old network name (which was confirmed in the app) and went on to re-set my entire deco network (4 deco m9s).

with the fresh setup, it says I cannot use my old network name because it is occupied. How come? It was deleted!

How do I terminate this ghost-network?

1 Reply

2019-12-09 03:41:55

Posts: 21605

Helpful: 5052

Solutions: 2546

Stories: 21

Registered: 2018-12-24

Re:Old networks

2019-12-09 03:41:55

How did you delete the old network name?

Try to power cycle the whole wifi system and re-set the Deco network name.

If still the same, you can hold the reset hole for 1s to reset it and start it from the scratch.

May it help.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.