Home Network Community > Range Extenders > Re200 Ethernet connection
< Range Extenders

Re200 Ethernet connection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Re200 Ethernet connection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Re200 Ethernet connection
Re200 Ethernet connection
2020-02-12 18:53:37 - last edited 2020-02-12 22:26:00

Hey all,

 

i bought one of these to produce a WiFi network from my studio, which is hardwired to my router in my house. It is too far to extend the network wirelessly but the sales assistant said to plug the Ethernet into it and that would work. It does actually work, but creates  all sorts of problems with the connection in my house. 
 

am i right in assuming that the Ethernet on thé RE200 is an 'outgoing la port rather than in 'incoming' port and so I have the wrong thing?

 

any advice?

 

cx

  0      
 
  0      
 
#1
Options
4 Reply
Re:Re200 Ethernet connection
2020-02-13 02:35:24

@Whatever21 RE200 supports two operation mode: RE mode(Default), and AP mode. See the different below.

 

RE mode: Extend the existing the wireless range.

 

Topology: Router)))) Wireless((((RE200))))wireless((( PC/phone

 

 

AP mode: Transfer the wired network to a wireless one.

Topology: Router---cable--RE200))) wireless(( PC/Phone

  0  
  0  
#2
Options
Re:Re200 Ethernet connection
2020-02-14 09:03:33

@Whatever21 

 

Hello, you need configure RE200 as an access point to boost wifi signal by connecting it to the main router by wired cable.

 

Below is the instruction:

https://www.tp-link.com/en/support/faq/1401/

 

May it help.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#3
Options
Re:Re200 Ethernet connection
2020-02-14 09:55:22

@Kevin_Z thanks for the tip. Will do that today. X

  0  
  0  
#4
Options
Re:Re200 Ethernet connection
2020-02-14 13:18:18

@Whatever21 So, I did all that as per the instructions, but now whenever I try to join either the 2.4 or 5qhz networks it tells me I have an incorrect password, I"ve tried a few different things but I'm at a bit of a loss...

 

Any ideas?

  0  
  0  
#5
Options

Information

Helpful: 0

Views: 2129

Replies: 4

Related Articles
 re200, ethernet connection not working
1755 2
 RE200 Ethernet connection speed capped at 100Mbps
1170 0
 RE200 v1 only ethernet
689 0
 RE200 -- ethernet to hub
1806 0
 RE200 connected to another RE200 via Ethernet
715 0
Re200 not connecting
327 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.