Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > So did i get the setup right with cables and switch?

< Deco

So did i get the setup right with cables and switch?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

So did i get the setup right with cables and switch?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

NvC

2020-03-05 11:17:05

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-03-05

So did i get the setup right with cables and switch?

2020-03-05 11:17:05

Model: Deco M9 Plus

Hardware Version:

Firmware Version:

I have just bought the TP-Link Deco m9 3 pack, and the TP-Link switch 8 Ports Network IGMP, 10/100/1000 Mbps.

and want to besure my setup is right, before I start.

please let me know.

Setup:

(existing router put in to bridge/modem mode only. Deco m9 in router mode.)

Coax cable modem - - - Deco m9(main) - - - TP link switch:

Deco m9 (slave) - - - Tv direct cable into switch.

Deco m9 (slave).

Computer direct cable into switch.

Another question:

Is it important to connect the deco m9 wireless before i connect with cable?

1 Reply

Kevin_Z

2020-03-06 02:14:12

Posts: 21609

Helpful: 5056

Solutions: 2546

Stories: 21

Registered: 2018-12-24

Re:So did i get the setup right with cables and switch?

2020-03-06 02:14:12

@NvC

Hello, you can locate them like the diagram attached. The Deco M9 Plus can connect to each other by wired cable or wireless, and you can plug in a switch between the two Decos.

As for the second question, it does not matter. You can connect the slave Deco to the main Deco by wireless or wired cable to configure.

Good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

So did i get the setup right with cables and switch?

So did i get the setup right with cables and switch?

Information

Voters 0

Tags