Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Deco M9 Plus - Channel Bandwidth Configuration and UPNP

< Deco

Deco M9 Plus - Channel Bandwidth Configuration and UPNP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M9 Plus - Channel Bandwidth Configuration and UPNP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Teknowolff

2020-03-06 04:44:00

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-03-06

Deco M9 Plus - Channel Bandwidth Configuration and UPNP

2020-03-06 04:44:00

Model: Deco M9 Plus

Hardware Version: V1

Firmware Version: 1.3.0 Build 20190821 Rel. 54023

Good evening.

Fired up a set of P9 Plus units today and am happy with the wireless performance.

Sub-second roaming hand-off rocks!

I don't like stepping on my neighbors with 40 MHz spread on 2.4 MHz channels, and not being able to disable UPNP concerns me.

Is it possible to manually change the channel bandwidth and disable UPNP?

Is Terminal (Telnet, SSH) an option to configure the devices manually?

Until then I'll likely put the P9's in AP only mode and put them behind an independent gateway.

THX

2 Reply

Kevin_Z

2020-03-06 12:14:49

Posts: 21750

Helpful: 5134

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:Deco M9 Plus - Channel Bandwidth Configuration and UPNP

2020-03-06 12:14:49

@Teknowolff

Hello, there is no option to change wireless channel width, and it does not support telnet or SSH.

The UPnP option is enabled by default. and this new feature to toggle it on/off will be added with firmware upgrade.

Good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

DManel

LV1

2020-10-02 18:24:19

Posts: 5

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2020-10-02

Re:Deco M9 Plus - Channel Bandwidth Configuration and UPNP

2020-10-02 18:24:19

@Kevin_Z

I have the same issue with the newer deco X20.

Upnp is enabled by default and there's no option to disable it.

Do you have any feedback about when this option will become available?

Deco M9 Plus - Channel Bandwidth Configuration and UPNP

Deco M9 Plus - Channel Bandwidth Configuration and UPNP

Information

Voters 0

Tags