Home Network Community > Deco > Deco M9 Plus - Channel Bandwidth Configuration and UPNP
< Deco

Deco M9 Plus - Channel Bandwidth Configuration and UPNP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M9 Plus - Channel Bandwidth Configuration and UPNP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M9 Plus - Channel Bandwidth Configuration and UPNP
Deco M9 Plus - Channel Bandwidth Configuration and UPNP
2020-03-06 04:44:00
Model: Deco M9 Plus  
Hardware Version: V1
Firmware Version: 1.3.0 Build 20190821 Rel. 54023

Good evening.

 

Fired up a set of P9 Plus units today and am happy with the wireless performance. 

 

Sub-second roaming hand-off rocks!

 

I don't like stepping on my neighbors with 40 MHz spread on 2.4 MHz channels, and not being able to disable UPNP concerns me. 

 

Is it possible to manually change the channel bandwidth and disable UPNP?

 

Is Terminal (Telnet, SSH) an option to configure the devices manually?

 

Until then I'll likely put the P9's in AP only mode and put them behind an independent gateway.

 

THX

 

 

  0      
 
  0      
 
#1
Options
2 Reply
Re:Deco M9 Plus - Channel Bandwidth Configuration and UPNP
2020-03-06 12:14:49

@Teknowolff 

 

Hello, there is no option to change wireless channel width, and it does not support telnet or SSH.

 

The UPnP option is enabled by default. and this new feature to toggle it on/off will be added with firmware upgrade. 

 

Good day. 

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options
Re:Deco M9 Plus - Channel Bandwidth Configuration and UPNP
2020-10-02 18:24:19

@Kevin_Z 

I have the same issue with the newer deco X20.

Upnp is enabled by default and there's no option to disable it.

Do you have any feedback about when this option will become available?

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1760

Replies: 2

Related Articles
Deco m9 wifi channel
11727 4
 Deco M9 Plus Home “Layout” change after initial setup/configuration
1972 0
 Deco M9 Plus - Appears to throttle bandwidth
4666 3
Questions about Deco M9 Plus
901 0
Deco M9 Plus V2
1251 0
Deco M9 Plus limitations
706 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.