Master/slave DECO M4

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Master/slave DECO M4
Master/slave DECO M4
2020-03-21 01:40:42
Model: Deco M4
Hardware Version:
Firmware Version:

Wifi configuration

Modem - DECO M4 (Master) - Switch - DECO M4 (Slave)

 

- all connection among above 4 device is through ethernet.

 

With this configration, 

  1. When I enable 1st mobile device with DECO M4 master wifi, that device is working with DECO M4 master and slave wifi.

  2. But when I try to connect DECO M4 slave wifi first with 2nd mobile device, it is not working even though 1st mobile device is still working with DECO M4 slave wifi.

 

Any advice to fix this issue?

0
0
#1
Options
1 Reply
Re:Master/slave DECO M4
2020-03-23 01:56:49

@Astroid94 

 

Here are a few things we need to confirm to locate this issue. What is the led status of the two Decos? With a computer connected to the slave Deco by wired cable, can it access internet? Please click here to get the IP address and gateway with mobile device connected to the slave WiFi. 

 

You can switch the slave Deco to the main one and swap their locations to give it a go. 

https://www.tp-link.com/support/faq/2400/ 

0
0
#2
Options