Home Network Community > DSL Modem&Routers > Archer VR600V on Telstra FTTN
< DSL Modem&Routers

Archer VR600V on Telstra FTTN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer VR600V on Telstra FTTN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR600V on Telstra FTTN
Archer VR600V on Telstra FTTN
2020-03-29 22:01:22
Model: Archer VR600v  
Hardware Version: V2
Firmware Version: 1.0.0 0.9.1 v0078.0 Build 170814 Rel.66346n

Hi,

 

I have an Archer VR600V connected to a Telstra FTTN NBN supply, which is working very well, but the Analogue Voice Port is not working. Can anyone please shed some light on what the required settings for Telstra area please as the Telstra Modem we had before was set to Auto Provision Voice Service.

 

Thanks in advance.

Robert

Security systems integrator based in Tasmania, Australia.
  1      
 
  1      
 
#1
Options
2 Reply
Re:Archer VR600V on Telstra FTTN
2020-03-30 07:42:09

@BobsterC Hi, do you have a VOIP service from Telstra? If so, you may refer to the instruction below to do the settings.

https://www.tp-link.com/support/faq/2020/

  0  
  0  
#2
Options
Re:Archer VR600V on Telstra FTTN
2020-04-08 22:34:24

 

Stella.Q wrote

@BobsterC Hi, do you have a VOIP service from Telstra? If so, you may refer to the instruction below to do the settings.

https://www.tp-link.com/support/faq/2020/

@Stella.Q 

Yes it is a VoIP service from Telstra, but Telstra was not listed in those instructions you sent?

Security systems integrator based in Tasmania, Australia.
  0  
  0  
#3
Options

Information

Helpful: 1

Views: 1315

Replies: 2

About Us
Press
Copyright © TP-LINK CORPORATION PTE. LTD. All rights reserved.