Archer C60 AC 1350Mbps - Access Point ip
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi There,
I have a Archer C60 AC 1350Mbps and use it as access pointer which connected to zte router. I set up it as access point by replacing default ip to zte's range and connected to it. I disabled dhcp. So, i cannot get into Archer c60, neither with http://tplinkwifi.net/ nor any other way such as tether vs. I cannot find ip of access point. I dont want to reset it. So, is it possible to find its ip ?
Thanks for all help
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, did you remember the LAN IP you setup for the Archer C60 when you configure it as an access point? If so, you can use the IP address to log into the web UI.
Otherwise, I'm afraid that you have to reset it to log in.
Good day.
- Copy Link
- Report Inappropriate Content
Hi, did you remember the LAN IP you setup for the Archer C60 when you configure it as an access point? If so, you can use the IP address to log into the web UI.
Otherwise, I'm afraid that you have to reset it to log in.
Good day.
- Copy Link
- Report Inappropriate Content
@Kevin_Z The problem is this, I dont remember this ip. I tried a few but did not work. as a access point i can not get its ip from lan. when i enter 192.168.1.1 it enters zte router, this is the gateway. Also, when i search lan with ip range i cannot find C60, but it is there. I connect it to reach internet. Interesting problem!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 854
Replies: 2
Voters 0
No one has voted for it yet.