AX50 USB3 transfer very slow
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
AX50 claims to have USB3.0 enabled port but my transfer speed is very slow. 20-30 MB/S through wired 1gbps ethernet and 1.5gbps wifi. So basically USB2 speeds. Tried several usb3 hdds and usb3 ssd. Still the same. Disabled/enabled USB 3.0 Interference Reduction in system parameters but no improvement. Firmware is up to date.
Can anyone help with this?
This router is serious junk. Wish I could return it.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@steve79 Use a TPlink AX10 + Raspberry pi4 as NAS. Solved.
- Copy Link
- Report Inappropriate Content
@Melqui I have struggled with this for a few months and somehow just got it to work. This is worth trying for anyone else struggling to get good speeds between two computers in the sam AX50 network.
- Go to Advanced settings on web browser
- Navigate to Operation Mode on the left sidebar
- The default is set to Router. Change to Access point and reboot
- After reboot change back to Router and reboot.
- Enjoy fast transfer speeds.
- Copy Link
- Report Inappropriate Content
@steve79
I had the same problem with my AX50/3000, until I replaced it with an Asus RT-AX86U. This has fixed the problem. I now get 110MB/s transfer speed over network to my WD Elements 14TB. TP-Link support should pin this easy fix on top of this useless thread...
- Copy Link
- Report Inappropriate Content
Information
Helpful: 5
Views: 11816
Replies: 23
Voters 3
