Home Network Community > DSL Modem&Routers > Archer VR2800 not connecting to NBN satellite box
< DSL Modem&Routers

Archer VR2800 not connecting to NBN satellite box

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer VR2800 not connecting to NBN satellite box

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR2800 not connecting to NBN satellite box
Archer VR2800 not connecting to NBN satellite box
2020-04-25 08:14:25
Model: Archer VR2800  
Hardware Version: V1
Firmware Version: ?

No upgrades available for Firmware, latest apparently installed.

 

Problem:

Cannot get 2800 to indicate internet connection in led display.

Therefore cannot get on to internet to install.

SSiD's not being identified [seen] as networks.

 

Tried to reinstall Firmware but not accepted in Advanced.

 

Set up:

Mac Os. iMac

Westnet provider NBN satellite connection [pppeo] ; [works through Budiilite modem, as now].

NBN connected but no internet showing in TP-Link 2800 Led display.

Correctly wired from Lan [NBN] to Lan/Wan on 2800.

Have reset numerous and booted all equipment.

  0      
 
  0      
 
#1
Options
3 Reply
Re:Archer VR2800 not connecting to NBN satellite box
2020-05-09 01:44:07
Satellite NBN requires a router to connect, you purchased a DSL modem. Set this modem to a wireless router mode and try setup it.
  0  
  0  
#2
Options
Re:Archer VR2800 not connecting to NBN satellite box
2020-05-09 01:44:45
Satellite NBN requires a router to connect, you purchased a DSL modem. Set this modem to a wireless router mode and try setup it.
  0  
  0  
#4
Options
Re:Archer VR2800 not connecting to NBN satellite box
2020-05-09 09:25:55

@NothingElse 

 

 

Had a reply ready but it dissappeared.

 

Thanks, Will follow your advice when new unit arrives [I hope].

 

some further rcommendtions: Leave everything default [?] other than -

 

ISP: Other

DSL mod: VDSL

VLan I/D: N/a

Annex: A

SRA: enabled

Internet connect.: Dynamic IP

Rest, leave as default ....

 

but there are other 'recommendations and settings' ????? including DNS addresses and username and password [which may be part of default]

 

Let you know how I go

  0  
  0  
#5
Options

Information

Helpful: 0

Views: 1045

Replies: 3

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.