Archer MR600(EU) V1 - BETA Firmware - Allowing selection of 4G+bands for Archer MR600 manually
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi all,
Following the long thread on the same subject discssing the BETA FW, as I said I would, TPLink have given me permission to share the FW download llink.
From TPLink - We recently released a beta firmware for Archer MR600(EU) V1 which can allow us to select 4G+bands for Archer MR600 manually.
https://static.tp-link.com/2020/202004/20200420/Archer_MR600v1_1.1.0_0.9.1_[200417-rel75138]_up_boot_2020-04-20_08.44.31.zip
For Archer MR600, if you want to use its 4G+network, your SIM card should support the CA bands group Archer MR400 supports. Please check the attached picture and check if your SIM card supports the band groups on the list or not.
They asked me to state that, this BETA FW is for the Archer MR600(EU) V1 ONLY!
Neither TPLink nor me take any respnsbility if you flash a none-EU router.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
It has gone completely.
I can only pick up one band, so it was no loss for me to try the new firmware.
Not a lot has changed from the first to be honest. No more stable, no more options.
The channel choosing option is no where to be seen.
- Copy Link
- Report Inappropriate Content
@Nevsie Same as I buy the speeds are the same... As with myself, I only ever connect to 3,3.
- Copy Link
- Report Inappropriate Content
But 3,3 means you are getting band 3 from two different masts.
I am literally just getting 3, not a second band at all.
But I am line of sight, and get 100+ down and 30+ up.
- Copy Link
- Report Inappropriate Content
@darant My Router is on latest version but when I try going for Beta FW you provided in the kink it says Error 4503 the uploaded file was not accepted.
can you help me for the manual setting of Band for 4G+.
Thank you in advance
Firmware Version: 1.2.0 0.9.1 v0001.0 Build 200511 Rel.44954n
Hardware Version: Archer MR600 v1 00000001
- Copy Link
- Report Inappropriate Content
Are you uploading the ZIP or extrracting the .bin file from it and uploading that?
- Copy Link
- Report Inappropriate Content
Tried uploading the zip file. Wasn't sure I Should go for unzip and upload as I'm not into router breaking, if it would have been mobile I would have tried it.
Should I unzip the file and upload?
- Copy Link
- Report Inappropriate Content
https://community.tp-link.com/en/home/forum/topic/210488
Yes upload the bin file.
Instruction in the first few posts of the above link.
- Copy Link
- Report Inappropriate Content
@darant How to get back to older version if it fails
- Copy Link
- Report Inappropriate Content
Is it the beginning of a guide or is it a question?...
- Copy Link
- Report Inappropriate Content
Is there any other beta FW which supports more bands for Carrier Aggregation?
We have limitations here for CA bands, so it would have been great if we had just few more compatible bands to work here in India.
Eg. 1+3,1+40,1+41,3+41 etc
- Copy Link
- Report Inappropriate Content
Information
Helpful: 13
Views: 194053
Replies: 511
Voters 10
