Archer MR600(EU) V1 - BETA Firmware - Allowing selection of 4G+bands for Archer MR600 manually
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi all,
Following the long thread on the same subject discssing the BETA FW, as I said I would, TPLink have given me permission to share the FW download llink.
From TPLink - We recently released a beta firmware for Archer MR600(EU) V1 which can allow us to select 4G+bands for Archer MR600 manually.
https://static.tp-link.com/2020/202004/20200420/Archer_MR600v1_1.1.0_0.9.1_[200417-rel75138]_up_boot_2020-04-20_08.44.31.zip
For Archer MR600, if you want to use its 4G+network, your SIM card should support the CA bands group Archer MR400 supports. Please check the attached picture and check if your SIM card supports the band groups on the list or not.
They asked me to state that, this BETA FW is for the Archer MR600(EU) V1 ONLY!
Neither TPLink nor me take any respnsbility if you flash a none-EU router.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Thanks for getting back.
The tech team was made aware of your issue, they will likely reach out to you via email to continue to troubleshoot your issue.
- Copy Link
- Report Inappropriate Content
Hi guys. update to be installed manually, must be installed as a zip file as well as the download?
- Copy Link
- Report Inappropriate Content
guys can anyone answer me?when I download the zip file, do I have to update it unpack the file or directly as a zip file?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Questo rooter deve arrivare a me in pochi giorni, l'ho comprato ieri.
Ho visto che l'ultimo aggiornamento è del 28.12.20. questo aggiornamento ha già la possibilità di selezionare the bands manually?
Devo installare il firmware beta che trovo nella prima pagina di questo forum o con l'ultimo aggiornamento va bene?
- Copy Link
- Report Inappropriate Content
for bandselection you need to install the beta-fw. this function isnt given in the latest official fw..
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
as far as i know its only for V1 routers. but im not sure to be honest. maybe the devs could answer that question.. but i doubt anyone of them is looking in here whats going on
- Copy Link
- Report Inappropriate Content
Information
Helpful: 13
Views: 194508
Replies: 511
Voters 10
