Use Extender as an Access Point
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Use Extender as an Access Point
I am attempting to set up my RE200 Extender as an Access Point and have followed the instructions in the user manual, but have hit a snag!
The instructions state that after logging into http://tplinkrepeater.net I should click on Mode in the top right corner of the page!
There is no Mode in the top right of the page, or anywhere else on the page! It simply has a header with TP-Link and the model number, below which are the following setting options.
Status
Quick Setup Wizard
Network
Wireless
LED On/Off
System Tools
I have checked each of these and can find no Mode selection available!
The only possible I can find is within Wireless / Advanced Settings, which gives me a selection option of 'Enable AP Isolation'!
Any ideas?
1 Accepted Solution
