Deco M5 satellite node always connecting to master node instead of a nearer satellite node
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a Deco M5 mesh network with one master node and 2 satellite nodes, say satellite_node_1 and satellite_node_2.
The node satellite_node_1 has good signal from the master node and no issues here.
And my node satellite_node_2 is nearer to the satellite_node_1. But still it is always getting connected to the master node which is more far, and thus having weaker signal.
How can I make my satellite_node_2 connect to satellite_node_1 instead of the master node?
Regards
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@md_naveed Same problem here, there is no way node 2 will connect to node 1 in deco m4, it keeps connecting to main deco and I only have one "working" node since the second one gets really poor signal. Please send me the beta
- Copy Link
- Report Inappropriate Content
@TP-Link I have the same problem of satellite node connecting to the main node instead of the nearest node. I want to try the beta version as well. TIA
- Copy Link
- Report Inappropriate Content
@Rbhar Already sent and please check the message box.
- Copy Link
- Report Inappropriate Content
@TP-Link My Deco M5 slave nodes keep connect to the main node that is quite far away. Could you send me the beta firmware to try out?
Thanks
- Copy Link
- Report Inappropriate Content
Hi. im using deco m5 too. but the source signal appear for my 1st satellite is 2.4Ghz instead of 2.4Ghz/5Ghz. my firmware are the latest for both deco m5. eventhough both deco sit next to each other the source signal only showed 2.4Ghz..thanks in advance
- Copy Link
- Report Inappropriate Content
Hi, there is a firmware that allows us to manually select the signal source of Deco M5 only.
if you want to have a try, please check for your message box.
- Copy Link
- Report Inappropriate Content
please send it to me too!!
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@TP-Link I have the salter problem with a P9. Could i try the firmware? Thanks!
- Copy Link
- Report Inappropriate Content
@TP-Link Hello. I have the same issue with the X68. I have 4 x X68 units.
Do you have a Beta firmware for the Deco X68 that I could try please?
Ian
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 8927
Replies: 39
Voters 1
