Wifi Bridge new network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wifi Bridge new network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wifi Bridge new network
Wifi Bridge new network
2020-07-17 13:19:04 - last edited 2020-07-17 13:21:18
Model: Archer C2  
Hardware Version:
Firmware Version:

Hi

I have setup a wifi bridge from my wifi to my neighbours house and it works fine, but are there any way i can make the router setup its own network(ip and subnet) so the neighbours cant reach my devices like cromecast etc ? 

 

in a nutshell i want the router to use my wifi as an WAN

 

I have tried to activate the DHCP in the bridge router but it still uses my DHCP and shows everything on my lan.

 

  0      
  0      
#1
Options
1 Reply
Re:Wifi Bridge new network
2020-07-20 02:56:41

@Sjostein 

 

Is it the Archer C2 works in bridge mode to extend your neighbor's Wi-Fi to your house, or C2 is the main router and your neighbor is using its Wi-Fi by a bridge connection?

 

If it is the previous, we may say sorry that we cannot block that communication between the LAN devices. If it is the latter, you may ask your neighbor to extend the guest network and disable the gues to access your local network.

 

Good days.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options