I would like to configure it as a repaeter or a bridge mode, how can i do it?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2020-07-23 18:39:14 - last edited 2020-07-24 11:04:18

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-07-23

I would like to configure it as a repaeter or a bridge mode, how can i do it?

2020-07-23 18:39:14 - last edited 2020-07-24 11:04:18

Model: Archer A10

Hardware Version: V1

Firmware Version: last one

Hi I would like to configure this eouter in a repeater mode or bridge mode, how can i do it?

1 Accepted Solution

2020-07-24 11:04:12 - last edited 2020-07-24 11:04:18

Posts: 21750

Helpful: 5135

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re: I would like to configure it as a repaeter or a bridge mode, how can i do it?-Solution

2020-07-24 11:04:12 - last edited 2020-07-24 11:04:18

Hello,

Here is the guide for your reference to set up the A10 as a range extender:

May it help.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.