Link Aggregation Archer AX11000

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Link Aggregation Archer AX11000

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Link Aggregation Archer AX11000
Link Aggregation Archer AX11000
2020-07-29 10:35:59 - last edited 2020-07-31 10:22:18
Model: Archer AX11000  
Hardware Version: V1
Firmware Version:

I have enabled Link Aggregation in the router's setup, but when I set Server 2016 to LACP it gives an error of negotiation failed. If I set the server to use Static or Switch Independent the team shows as working, I was under the impression this router supported LACP

  0      
  0      
#1
Options
1 Accepted Solution
Re:Link Aggregation Archer AX11000-Solution
2020-07-31 10:21:51 - last edited 2020-07-31 10:22:18

@Braden 

 

Hello,

 

As per the Link Aggregation settings on your server, it should be Static mode, below is the instructions you may refer to:

https://www.tp-link.com/support/faq/1583/

 

Good days.

If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Link Aggregation Archer AX11000-Solution
2020-07-31 10:21:51 - last edited 2020-07-31 10:22:18

@Braden 

 

Hello,

 

As per the Link Aggregation settings on your server, it should be Static mode, below is the instructions you may refer to:

https://www.tp-link.com/support/faq/1583/

 

Good days.

If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1895

Replies: 1

Related Articles