Archer A6 WDS setup
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I'm trying to set up a WDS connection so I can work with my router without the ethernet cable plugged to it. I found the way to enable WDS option under advance options / system parameters. Now the option is enabled as you can see on the attached image but once I disconnect the ethernet cable it stops transmitting. What can I do to make it work as a repeater without ethernet cables? Any ideas are very appreciated.
PS: I deleted my network info on the image, but it's been already set up on my router.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello,
If you want to connect this Archer A6 wirelessly to your existing wireless router, you can enable the WDS bridging function to give it a go:
https://www.tp-link.com/support/faq/1555/
May it help.
- Copy Link
- Report Inappropriate Content
Hello,
If you want to connect this Archer A6 wirelessly to your existing wireless router, you can enable the WDS bridging function to give it a go:
https://www.tp-link.com/support/faq/1555/
May it help.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hello,
You can give the A6 the same name as on your main wireless router.
If the WDS connection is not stable, please check below:
1. When the A6 stops working, with your computer connected to it, please check if you still get an IP address/gateway from it.
2. Ensure the internet connection on your main wireless router is stable, you may connect a phone or laptop to it and confirm.
3. How far away between the 2 routers? Try to move the A6 closer to the main router.
4. Ensure that the firmware of the A6 is up-to-date.
Good days.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 6053
Replies: 4
Voters 0
No one has voted for it yet.