Archer XN020-G3v modem page shows "debug use, for tp-link internal use only"
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer XN020-G3v modem page shows "debug use, for tp-link internal use only" , how to disable/remove it. Is this text showing in every tp link modem page? any help? thanks in advance
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Good day.
Did you update some beta firmware from TP-Link since the watermark cannot be removed?
And normally, you might need to update to another suitable firmware to get rid of the mark.
Thank you!
- Copy Link
- Report Inappropriate Content
@Sunshine Thanks for the reply. I didn't do a beta update. How to find suitable firmware for my modem model(XN020-G3v)?
- Copy Link
- Report Inappropriate Content
Good day,
Thank you very much for your time and patience.
May I know where are you located and who is your internet service provider?
Are your XN020-G3v GPON router given by the ISP，and did the web interface display like that since you got it or you accidentally update the debut firmware from somewhere else?
Later, I could check with the local support to see if they could provide any help;
Thank you very much.
- Copy Link
- Report Inappropriate Content
My location: edappal, kerala
ISP : BSNL
Web interface shows from the begining, when i got it from service provider.
Thank you
- Copy Link
- Report Inappropriate Content
@sathuvish I'm having the same issue. I'm also on some custom firware that the LCO has provided :
The specs for XN020 state it supports IPSec VPN , but I dont' see any option in this custom firware to setup a VPN connection.
- Copy Link
- Report Inappropriate Content
My router which i bought from outside also shows the same after ingave it to bsnl for configuration
How can they change our router to custom firmware without our onowledge.?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2184
Replies: 6
Voters 0
No one has voted for it yet.