****Archer MR600 - 2CA bands Aggregation - New Bands***
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi TP Link team, Looking forward for 40A + 40A Carrier aggregation support on MR600 v1 . The last beta firmware provided doesnt support the same. Also i believe last beta was released in April 2020, can you release the new beta / general software to support 40A-40A CA?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Sunshine thx for the reply. We all in India are eagerly waiting for this...
- Copy Link
- Report Inappropriate Content
@Abhi093 in one of your posts you mentioned LPDA antenna dint worked for you and you tried patch panel, i am planning for LPDA antenna, May i know why?
- Copy Link
- Report Inappropriate Content
Hi, Can you atelast confirm if its hardware or software change?
Last beta was made available in April 2020, its already 5 months of waiting. Request you to expedite it.
- Copy Link
- Report Inappropriate Content
@Indian-techie @Sunshine awaiting for it..
- Copy Link
- Report Inappropriate Content
@Sunshine I could confirm that in my area the network provider Jio providing 2_CA 40A+40A total of 30 MHz channel width. Kindly ask your developers for a firmware release to support this aggregation . We all in India waiting for this since days.
- Copy Link
- Report Inappropriate Content
@Abhi093 there is also 4CC available from Airtel India in some of its towers. But due to my phone restrictions I only get 2CC.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@AP_Techie hi,
It's netmonster . Yes latitude and longitude are also captured from which BTS your device is latched to. And it also shows the nearby towers.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 10944
Replies: 60
Voters 1
