C80_Multiple_bandwidth_allocation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2020-08-27 10:38:20 - last edited 2020-08-28 02:50:29

Posts: 6

Helpful: 3

Solutions: 0

Stories: 0

Registered: 2020-08-27

C80_Multiple_bandwidth_allocation

2020-08-27 10:38:20 - last edited 2020-08-28 02:50:29

Model: Archer C80

Hardware Version:

Firmware Version:

Hi All,

I have got a new C80 router for home use.

Trying to figure out how to allocate limited bandwidth for some devices connected to the router.

Bascially, I want to allocate around 500 Kbps speed to few devices and 2 Mbps to few and so on....

Please provide some assistance for the same.

Thanks,

Daryl

1 Accepted Solution

2020-08-28 02:50:08 - last edited 2020-08-28 02:50:29

Posts: 21773

Helpful: 5145

Solutions: 2574

Stories: 21

Registered: 2018-12-24

Re:C80_Multiple_bandwidth_allocation-Solution

2020-08-28 02:50:08 - last edited 2020-08-28 02:50:29

Hello,

The Archer C80 supports QoS only, and it no longer supports set certain bandwidth for a specific device.

Below is the instruction to configure the QoS setting (there might be a slight difference from your web UI):

May it help. Good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.