Unable to open router web interface over OpenVPN connection
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to open router web interface over OpenVPN connection
Model:
Archer VR2800
Hardware Version: V1
Firmware Version: 0.5.0 0.9.1 v006c.0 Build 200710 Beta.50656n
Hello
I have setup OpenVPN and able to connect and access my computers over the network. However, I am unable to open the router web interface (192.168.1.1) and always get "403 Forbidden", which seems kinda strange.
What could be wrong?
Please help me to resolve this "issue"
regards
1 Accepted Solution
Re:Unable to open router web interface over OpenVPN connection-Solution
Good day.
Sorry for the delay.
For your case, we might need your help to check the following information:
- Can I have a picture of the network adapters settings page?
- What is your IP address when you enabled the OpenVPN on the computer?
- If trying to ping 192.168.1.1, what could you get?
Thank you very much.
Re:Unable to open router web interface over OpenVPN connection-Solution
Good day.
Sorry for the delay.
For your case, we might need your help to check the following information:
- Can I have a picture of the network adapters settings page?
-
- What is your IP address when you enabled the OpenVPN on the computer?
- If trying to ping 192.168.1.1, what could you get?
Thank you very much.