Very Urgent-Requesting new Beta firmware for switch between 4G bands on Archer MR200 V5
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Very Urgent-Requesting new Beta firmware for switch between 4G bands on Archer MR200 V5
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
@Sunshine Kindly reply
@Sunshine Kindly reply
Hi.
In this below link you have given the beta firmware for manual LTE network band Selection upto Archer MR 200 V4.Kindly release the same for V5 too.Please put this on first priority..
I recently switched from Huawei to this router. The performance is horrible from Day 1. The router keeps switching from LTE band 1 and 40 and gets disconnected every time. Its very difficult to work in these times of Covid 19 when i have to work from home and i get disconnected every 2 mins because of band switching. Please suggest a way out of this, otherwise, customers like me will go back to Huawei as that performs seamlessly against these conditions.Without this function, this router perform so badly that sharing hotspot via smartphone yield similar result. This is quite Urgent!!!! Can we at least get a Beta version like how it was given for MR200 v4 in the below post.
Because offcial firmware would take months to release.So kindly release beta firmware for V5 version as you did for V4
PS:I had other no other option other than returning the router back to the Flipkart,If i did not get beta firmware.
Please understand my situation My router Is slower than my mobile hotpsot due to auto band switching. i am not able to use the router at all for work from home
KIndly forward the mail to your Global HQ team too and give beta fimware for archer MR 200 V5 asap
Forum Thread which has release Beta firmware for- Archer MR 200 V4:
https://community.tp-link.com/en/home/forum/topic/166506?page=1
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi all
I'm new to TP-Link, and liking what I see so far.
I haven't tried the Beta firmware for MR200 v5, will be trying tomorrow. It's a bit unclear from the screenshot whether you can select multiple bands. Is that possible with the new firmware?
If not, then will I be able to use something like LTEView to set multiple bands?
Thanks.
Rob
- Copy Link
- Report Inappropriate Content
Hello, thanks for asking.
The MR200 doesn't support Carrier Aggregation, the beta only allows you to select the band manually, you may check the specifications on the official website:
https://www.tp-link.com/home-networking/3g-4g-router/archer-mr200/#specifications
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Also looking urgently for firmware upgrade for MR 200 v3.
I've installed the Beta firmware but no results... all interface and functions are messy now.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 13
Views: 7607
Replies: 19
Voters 5
