Deco M4 setup with Maxis Fibre 300mbps
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I just got Deco M4. current setup is Maxis fibre 300mbps with Huawei modem and Tplink archer c5v router
1) is it advisable to replace C5v with M4 as main modem or shld we justt use M4 as AP with c5v?
2) if were to replace c5v with m4 as router, during pppoe setup shld i choose maxis1 profile or maxis2 profile? what is Maxis VLAN code?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
dzy wrote
@OJW i just bought a mesh, but I'm stuck at the ppoe username+password. is it below correct information to key-in?
PPOE anda adalah:-
Username: modemID@Maxis.home.com.my
Password: modemID+1 sebagai contoh xxxxxx1
given by maxis when i try to DM then. put into my mesh, led is red, not green.
any setting i missed?
@dzy above username/password can be applied for previous registered maxis fiber consumer (old one which modemID is just number. now maxis put an alphabet A in front of number)
for new registration. use ppoe as per below:
Username: AXXXXXX@home.maxis.com.my
Password: AXXXXXX
AXXXXXX is modemID
i made some tutorial on how to setting up for DECO X20: https://community.tp-link.com/us/home/forum/topic/271326?page=1
- Copy Link
- Report Inappropriate Content
@OJW I am facing the same issue like you. May I ask how did you resolve it?
- Copy Link
- Report Inappropriate Content
i replaced C5V with Deco as main router (connect to maxis huawei modem). Work like a charm and i able to get 300mbps full speed
- Copy Link
- Report Inappropriate Content
@OJW i just bought a mesh, but I'm stuck at the ppoe username+password. is it below correct information to key-in?
PPOE anda adalah:-
Username: modemID@Maxis.home.com.my
Password: modemID+1 sebagai contoh xxxxxx1
given by maxis when i try to DM then. put into my mesh, led is red, not green.
any setting i missed?
- Copy Link
- Report Inappropriate Content
dzy wrote
@OJW i just bought a mesh, but I'm stuck at the ppoe username+password. is it below correct information to key-in?
PPOE anda adalah:-
Username: modemID@Maxis.home.com.my
Password: modemID+1 sebagai contoh xxxxxx1
given by maxis when i try to DM then. put into my mesh, led is red, not green.
any setting i missed?
@dzy above username/password can be applied for previous registered maxis fiber consumer (old one which modemID is just number. now maxis put an alphabet A in front of number)
for new registration. use ppoe as per below:
Username: AXXXXXX@home.maxis.com.my
Password: AXXXXXX
AXXXXXX is modemID
i made some tutorial on how to setting up for DECO X20: https://community.tp-link.com/us/home/forum/topic/271326?page=1
- Copy Link
- Report Inappropriate Content
Thank you very much for the sharing
.
A small tip: If you post on the US community, it would be better to be written in English as well.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3559
Replies: 5
Voters 0
No one has voted for it yet.