Unable to access

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Unable to access

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to access
Unable to access
2020-10-06 05:24:42 - last edited 2020-10-07 06:05:11
Model: Archer VR900  
Hardware Version: V2
Firmware Version:

Can anyone suggest a way to log in to my router?  It doesn't seem to be generating a ip address and after a reset it takes about 5 minutes before it stops self testing (all lights flash for a few seconds then all off and starts up again) it was previously working, but haven't used it for 2 months. 

I have tried logging in using

192.168.1.1 

192.168.0.1

Http://tplinkmodem.net

Any advice greatly appreciated 

  0      
  0      
#1
Options
2 Reply
Re:Unable to access
2020-10-12 10:00:56 - last edited 2020-10-12 10:03:01

@Max9 

Good day.

Thank you very much for your kind reply.

May I know where are you located?

Did all the lights lit up currently, or they still kept flashing then off?

Could you please help me check the IP address and default gateway when the device is connected to the VR900, such as:

(If possible, please try to ping the default gateway to check the connection as well)

Thank you very much.

  0  
  0  
#2
Options
Re:Unable to access
2020-10-12 10:19:36

@Sunshine hi thanks in advance for the reply 

On further investigation I think my vr900 has given up, it continually tries resetting itself and eventually when it stops the power light continues to flash, sometimes the ethernet light comes on, sometimes not, when I do a ipconfig I can only get a automatic ipv4 address and no gateway, it may be time to give up....

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 407

Replies: 2

Related Articles