Tplink RE450 V3 doesn't work after flashing with OpenWRT

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tplink RE450 V3 doesn't work after flashing with OpenWRT

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tplink RE450 V3 doesn't work after flashing with OpenWRT
Tplink RE450 V3 doesn't work after flashing with OpenWRT
2020-12-24 17:07:03
Model: RE450  
Hardware Version: V3
Firmware Version:

Hi guys,

 

I've probably done something wrong when flashing a custom firmware for my Tplink RE450.

Now it starts as normally then after 20-30 seconds only POWER LED is on. Nevertheless, I can't connect to it and it's not visible via WiFi. Any ideas how to revert back to the original firmware?

 

Thanks in advance.

  1      
  1      
#1
Options
2 Reply
Re:Tplink RE450 V3 doesn't work after flashing with OpenWRT
2020-12-29 09:37:29

@WinterX 

Hello,

Thank you very much for your time and patience.

Would a factory reset on the extender help or not?

If nothing happened, I am afraid the extender is broken.

Really sorry for the inconvenience.

Thanks a lot for your understanding and support.

 

  0  
  0  
#3
Options
Re:Tplink RE450 V3 doesn't work after flashing with OpenWRT
2021-04-26 18:03:50

@WinterX I had a similar issue on RE450 v3 and managed to restore the original firmware after using these steps.

 

At that link you can find also an uploaded copy for the image I've used to restore the firmware. Be ware that this is valid for RE450 v3 only. 

You can compile the stripping project and adjust your image as needed starting from the official firmware version.

 

Best of luck!

  0  
  0  
#4
Options

Information

Helpful: 1

Views: 1795

Replies: 2