Setting method for connecting to NAS in LAN with Archer AX50
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I want to access the NAS in the LAN, but I can't. access the NAS.
I can access INTERNET.
The connection is in the order of： INTERNET → ROUTER → HUB → AX50 → PC.
However, PC → AX50 → NAS cannot connect.
LAN IP：192.168.1.xxx
SUBネット：255.255.255.0
GW：192-168-1.254
IP address system under ax50
LAN IP：192.168.0.1
SUBNET：255.255.255.0
Please tell me the setting method.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello, can you please check if the NAS is connected to the AX50 LAN or connected to the main router's LAN? What is the IP address on the NAS?
As per the layout, the PC should be in the 192.168.0.1 network, you need to ensure the NAS is also in this network, its IP address should be 192.168.0.x, but not 192.168.1.x.
You can either try to turn the AX50 into access point mode or connect the NAS to the AX50 LAN.
- Copy Link
- Report Inappropriate Content
Thank you, kevin.
Today I reconfigured the AX50.
I set it in bridge mode, but this time I was in trouble because I couldn't connect to the Internet.
When I was checking if there was any setting somewhere, I was able to solve it by setting a route from GW to NAS via WAN with static route setting.
- Copy Link
- Report Inappropriate Content
Do you mean you configured a static route on the AX50, then you can access the NAS from the PC? Is the device connected to the AX50 still having access to the outside internet?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1915
Replies: 4
Voters 0
No one has voted for it yet.