Connect a device to TP Link via Ethernet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Connect a device to TP Link via Ethernet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Connect a device to TP Link via Ethernet
Connect a device to TP Link via Ethernet
2021-02-08 14:22:03
Model: Deco M4  
Hardware Version: V7
Firmware Version:

Hi All,

 

I am trying to connect my Solar Panell comms unit to the internet via an ethernet cable to one of the ports on the M4 unit. The M4 unit blibks red and no communications.

 

Is this possible and how do I get this wired connection (direct connect to rour is not an option, due to distance)

 

Thx

  0      
  0      
#1
Options
1 Reply
Re:Connect a device to TP Link via Ethernet
2021-02-09 03:22:46

@HBS66 

Hi,

Thanks for your feedback.

the Solar Panel Kits should work fine with the Deco via Ethernet connection;

For your case, would you please help us check the following information:

  1. Please help me draw a picture of your network structure/map;
  2. Did Deco M4 units work on the access point mode, or wireless router mode?
  3. Did only the Deco that connected to the Solar Panell comms unit blink red? How about other units?
  4. Could you please send me a link of the Solar Panel Kits as well?

Thank you very much and wait for your reply.

  0  
  0  
#2
Options