Deco M4 select signal source
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I got 3 deco M4 device, 1 as main (AP mode) and slave 1 and slave 2.
Main deco and slave 1 are located at ground floor while slave 2 is located at floor 1.
Main deco is located under the stair so the signal strength is weak a bit, but the speedtest done when client device connect to slave 1 still good.
Problem here is slave 2 connect to main deco instead of slave 1 when slave 1 have greater signal strength compare to main deco.
I saw another post Deco M5 source signal selectable? got release beta firmware for M5 model.
May i know when will m4 beta firmware release? or does it have any other temporary solution?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Can you please share with me as well? Is the new firmware still in beta, I see the last post about 3 months ago.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Could you share an indication on the timeline of this new firmware, other than soon?
- I see that you are still actively sharing beta firmware for M5 model elsewhere on this forum. Would you be able to share if similar beta firmware is available for M4 and if so; please share with me.
Please do let us know whatever could help you to further push this issue to the top priority of the PD backlog. As you see there are quite some users who are strongly impacted by this issue since end 2019 (= 1,5 years and counting). I think we would be more than happy the help you get an indication of the amount of users being impacted by this and longing for a fix.
Thank you in advance
- Copy Link
- Report Inappropriate Content
Hi @TP-Link,
Please have a look on this issue again as we all here are still waiting for a new firmware that fix it.
I have facing this issue for along time and feel like I can't wait any longer :)
Thank you.
- Copy Link
- Report Inappropriate Content
Team, Need Solution for Fixing Signal Source Issue for my M4(Master) Which Connected to 2 Slave E4 Models.
Thanks for Support in advance
- Copy Link
- Report Inappropriate Content
@TP-Link Please send me also the firmware for M4 source selection. tqvm in advance =)
- Copy Link
- Report Inappropriate Content
Please refer to your email for further assistance.
- Copy Link
- Report Inappropriate Content
Hi, would like to ask for the m4 beta firmware signal source selector, having the same problems as the rest of the ppl here... Thanks..
- Copy Link
- Report Inappropriate Content
Hi, I checked via your TP-Link ID and found that your mesh system is a combination of Deco M5, M4 as well as M3W.
As for M4, your current firmware is 1.5.0 and the previous beta firmware is no longer suitable.
So would you be kind to start a new thread with the following information:
1. A picture of the floor map about the location and distance of the Deco units.
2. A picture of the web UI map.
Thank you very much.
- Copy Link
- Report Inappropriate Content
Hi, would like to ask for the m4 beta firmware signal source selector, also having problems with latest firmware
Thanks..
- Copy Link
- Report Inappropriate Content
Information
Helpful: 9
Views: 20084
Replies: 80
Voters 8
