M9 Plus firmware updates
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My V2s have updated from 1.5.0 to 1.5.1 but my router (v1) is still on 1.5.0 The support website only shows 1.5.0 for both models - has anyone seen the update for V1 models and why is the support website not up to date if the firmware is being pushed out automatically to V2s?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, I can see the latest firmware 1.5.1 for both V1 and V2 has been released on the global website and maybe there are some delay for local website;
https://www.tp-link.com/en/support/download/deco-m9-plus/v1/#Firmware
After updating the 1.5.1 on V2, would there be any issue about the new firmware?
Thank you very much and wait for your reply.
- Copy Link
- Report Inappropriate Content
Hi, I can see the latest firmware 1.5.1 for both V1 and V2 has been released on the global website and maybe there are some delay for local website;
https://www.tp-link.com/en/support/download/deco-m9-plus/v1/#Firmware
After updating the 1.5.1 on V2, would there be any issue about the new firmware?
Thank you very much and wait for your reply.
- Copy Link
- Report Inappropriate Content
Thanks - still not showing on UK website but have downloaded from global - no impacts on my V2 repeaters so far
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Evilcraig My v1 wont upgrade by webui or gdpr and tells me the firmware is up to date despite the bin file now being on the Uk wersbite as well
- Copy Link
- Report Inappropriate Content
@Evilcraig Replying to my own comment - I removed the v1 from the network, created a new network for the v1 only. Once it was in it's own network, I reached tplinkdeco.net and could upgrade to 1.5.1 via the bin file downloaded from here: https://static.tp-link.com/2021/202102/20210220/Deco_M9_Plus_V2_1.5.1_210126.zip Then I removed the new, temporary network which sets the v1 into factory default mode and added it as a new device back into the existing network. It worked just fine and now all devices have 1.5.1 installed. The ping problems and disconnects, flashing red lights etc that were observed with 1.5.0 have all been resolved.
- Copy Link
- Report Inappropriate Content
I didn't want to reset my V1 as it is the router and this c####y firmware doesn't allow you to save settings but your approach gave me an idea. I switched off all the V2s and the V1 upgraded straight away ! They really need to sort this stuff out - for a plug and play whole home system the upgrade procedure by itself is a nightmare - I'm beginning to wish I never changed to a mesh system
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1162
Replies: 7
Voters 0
No one has voted for it yet.