T2U archer can’t connect after Mac goes to sleep

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

T2U archer can’t connect after Mac goes to sleep

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
T2U archer can’t connect after Mac goes to sleep
T2U archer can’t connect after Mac goes to sleep
2021-02-22 17:37:25 - last edited 2021-03-03 12:06:35
Model: Archer T2U  
Hardware Version:
Firmware Version:

Hi my Mac does not detect the T2U Archer input after it goes to sleep and I on it back unless I shut down and restart computer again. I have already downloaded driver and connection is fine once computer restarts. So I have to restart laptop all the time?

  0      
  0      
#1
Options
1 Accepted Solution
Re:T2U archer can’t connect after Mac goes to sleep-Solution
2021-03-01 01:42:55 - last edited 2021-03-03 12:11:37

@Mco2.0   Hi, 

 

Please check "Energy Saver" settings on your MAC, Open the System Preferences, go to “Energy Saver” and make sure that you enable “Wake for Wi-Fi network access”.

If this does not help,  “Enable Power Nap” in both Battery Mode and Power Adapter Mode : https://support.apple.com/guide/mac-help/mchlp1168/mac

 

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:T2U archer can’t connect after Mac goes to sleep-Solution
2021-03-01 01:42:55 - last edited 2021-03-03 12:11:37

@Mco2.0   Hi, 

 

Please check "Energy Saver" settings on your MAC, Open the System Preferences, go to “Energy Saver” and make sure that you enable “Wake for Wi-Fi network access”.

If this does not help,  “Enable Power Nap” in both Battery Mode and Power Adapter Mode : https://support.apple.com/guide/mac-help/mchlp1168/mac

 

Recommended Solution
  0  
  0  
#2
Options