Deco P9 Keep Disconnect (PLC problem)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Deco P9 Keep Disconnect (PLC problem)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi.
I've a problem with the connection; it was OK previously but for couple of weeks the stability seems very bad with the satellite units
I have 3 units of P9 V1.
Already upgraded to the latest firmware..
Seems the PLC is not working well ; it keeps disconnected (if view from the status you can sometimes see PLC but sometimes dont)
Whats the solution to this?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@DanishS Please have a look at the private message.
Hi, would you please try to swap the location of the garage Deco and basement Deco to see whether garage Deco could maintain a PLC connection in a new location?
By the way, is Deco P9 set up under access point mode?
Sometimes, if there is a great interference on the electric wire, the PLC signal might get too weak to hold a stable powerline backhaul connection.
Thank you very much.
- Copy Link
- Report Inappropriate Content
@TP-Link Any new beta available?? will this update become official at any time? Im stuck on 1.1.3 Build 20201228 rel. 55057 waiting for an official release to fix the disconnect issue for one of the p9 in my three p9 setup
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 4643
Replies: 12
Voters 0
No one has voted for it yet.