Deco x20 IPTV

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco x20 IPTV

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco x20 IPTV
Deco x20 IPTV
2021-03-10 12:22:53 - last edited 2021-03-10 12:28:54
Model: Deco X20  
Hardware Version: V1
Firmware Version: 1.2.6 Build 20201013 Rel. 58271

Hello,

 

I have 2 units of deco x20, the main one is connected to the router by a LAN cable and the slave one is on a mesh WiFi.

My questions is how to setup IPTV on the main node? at the advanced tab under IPTV/VLAN i have try custom and bridge mode but still no luck.

In custom mode i only put IPTV VLAN ID and IPTV VLAN Priority and leave the Internet VLAN uncheck/blank and still no signal on my IPTV. If i change the mode to Malaysia-TM Unifi the internet went down. Anyone got any suggestion?

 

Thanks.

  0      
  0      
#1
Options
2 Reply
Re:Deco x20 IPTV
2021-03-11 08:28:58

@Ayoi 

Hi,  have you checked with the service provider about the IPTV configuration details?

And did it work fine with the previous router?

Was Malaysia-TM Unifi your internet and IPTV service provider?

Thank you very much.

  0  
  0  
#2
Options
Re:Deco x20 IPTV
2021-03-11 09:00:40 - last edited 2021-03-11 09:14:04

@TP-Link 

everything is working fine before i add the deco x20 router. my setup is like this modem > router (tp-link ax20) > 1st deco x20 (connected by LAN cable 1st port) > 2nd deco (mesh WiFi). i want to setup the 2nd port of the 1st deco work as IPTV. can it be done? 

Yes, my ISP is Malaysia-TM Unifi

  0  
  0  
#3
Options