Manual band selection for my 4G router MR 400 V1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Manual band selection for my 4G router MR 400 V1
Manual band selection for my 4G router MR 400 V1
2021-05-29 07:55:05 - last edited 2021-06-09 03:33:17
Hardware Version: V1
Firmware Version: 1.6.0 0.9.1 v0001.0 Build 181112 Rel.65058n

Any possible firmware version which allows me to manual 4G band selection. ?

Appreciate your help.

 

Model: Archer MR400 v1

 

Firmware Version:1.6.0 0.9.1 v0001.0 Build 181112 Rel.65058n 

Hardware Version:Archer MR400 v1 00000001 

0
0
#1
Options
1 Accepted Solution
Re:Manual band selection for my 4G router MR 400 V1-Solution
2021-06-09 03:33:11 - last edited 2021-06-09 03:33:17

@ravikrak 

 

Hi, MR400 V1 seems to be an old version, which was released years ago, we cannot guarantee that there will be a new firmware for it to allow the band selection.

 

However, you can check this with the local tech support to confirm if they could advise.

Recommended Solution
0
0
#4
Options
2 Reply
Re:Manual band selection for my 4G router MR 400 V1
2021-06-08 16:40:07

Any firmware update which allows me manual band selection for the below model ?.

 

Model: Archer MR400 v1

 

Firmware Version:1.6.0 0.9.1 v0001.0 Build 181112 Rel.65058n Hardware Version:Archer MR400 v1 00000001 

0
0
#3
Options
Re:Manual band selection for my 4G router MR 400 V1-Solution
2021-06-09 03:33:11 - last edited 2021-06-09 03:33:17

@ravikrak 

 

Hi, MR400 V1 seems to be an old version, which was released years ago, we cannot guarantee that there will be a new firmware for it to allow the band selection.

 

However, you can check this with the local tech support to confirm if they could advise.

Recommended Solution
0
0
#4
Options