Only one Antenna is working in TP Link MR600

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Re:Only one Antenna is working in TP Link MR600
2021-08-24 13:26:53 - last edited 2021-08-24 14:12:40

@SujitKrSahoo 

 

Yes, for best results both antennas MUST be connected.

1 external antenna only & 1 internal antenna will work but usually in Non - MIMO mode, (if the signal to internal antenna is low) for MIMO mode to work you require 2 internal antennas (if the signal is high) & for a best results, 2 external antennas are required, it all depends on your signal strength received, i.e how far you are from the cell tower/s.

A higher signal strength on both streams (4G+ MIMO) means higher speeds (Mbps).

 

Read this for more information ....  https://community.tp-link.com/en/home/forum/topic/272342

 

John vk3hjq

0
0
#12
Options
Re:Only one Antenna is working in TP Link MR600
2021-08-24 14:15:41 - last edited 2021-08-24 14:42:59

I thought you said it was only working on 1 antenna, & that was your problem in the 1st place.

 

Now for this Question .....For this to happen (& it can) the signal strength must be very high, i.e you are very close to the cell tower.

It is not a good idea to run it with only 1 antenna connected as it is designed to run with 2.

 

John vk3hjq

0
0
#13
Options