Time Setting
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Time Setting
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I connected my archer c24 as a repeater mode from archer ax20. Ax20 connected with internet cable and the router time is perfect. But my repeater router which is c24 the time is not perfect. I have to set manually from my device everytime after load-shedding. How to fix it. Why c24 didn't get time automatically from internet like ax20? help me please.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
They solved the problem today. Just set the Internet type dynamic IP(DHCP). The time works perfectly now. My IP was static that causes the problem. Thanks to Tp-Link.
- Copy Link
- Report Inappropriate Content
According to the router's manual (Chapter 6.6.) :
https://static.tp-link.com/2020/202008/20200825/1910012716_Archer%20C24(EU)_UG_V1.pdf
you should be able to set the time automatically even in range extender mode.
- Copy Link
- Report Inappropriate Content
I do it everytime to set the time. The router didn't set time from internet automatically. But why I have to do it everytime after load-shedding? Is there any way to set it automatically?
- Copy Link
- Report Inappropriate Content
I see that. But the ntp sever not working from internet. My zone is Dhaka GMT+6. But after load-shedding it set the default time not the exact one.
- Copy Link
- Report Inappropriate Content
Can you post the network map of C24:
Check C24 system log for any error messages.
Any error message when you set your time zone like this one:
Apart from time setting everything works as it should ?
What's the AX20 HW / FW version ?
- Copy Link
- Report Inappropriate Content
You are right brother. the 2nd ss problem show me everytime. NTP server not working.
- Copy Link
- Report Inappropriate Content
@terziyski- Copy Link
- Report Inappropriate Content
@terziyski- Copy Link
- Report Inappropriate Content
That 'poor network' status on the network map is the culprit for your issue (see how it should look like in my screenshot).
Have you checked your internet speed, what's the bandwidth ?
If there's is an option to connect C24 in AP mode (by ethernet cable) to AX20 that would probably solve the problem.
- Copy Link
- Report Inappropriate Content
AP mode not possible. Both router are set on different room. Poor connection not the issue I think. 🤔.
Cause my WR-845N also have same time setting problem. Which also set with repeater mode.
- Copy Link
- Report Inappropriate Content
Does it mean there are two repeaters connected to the AX20 network, and both of them cannot update the system time correctly?
Are both repeaters using static IP address when connecting to the AX20, or obtaining the IP address automatically? Try to change it to auto or DHCP if it is static, then check again.
You can also try to reset the C24 to factory defaults, then reconfigure it from scratch, leave the IP settings by default, then confirm.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2001
Replies: 15
Voters 0
No one has voted for it yet.