Pairing AV600 kit to Mesh M5 kit
Folks
Upgrades to M5 from AV600 kit , all good there, still need to use the AV600 to push an ethernet connection to garage. Bit unclear on the following
-Are they compatible
-If so do I plug the WPA4220 into original router or new main M5, have tried both and tried to reset the WPA4220 and AV600 and no joy so any step by step help appreciated
Thanks Paul
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, I guess your Deco M5 is on the wireless router mode, right?
Deco M5 and the AV600 kit, are compatible with each other;
Here are the steps for your reference:
- pair the AV600 kit first and make sure the powerline lights are on;
- then connect TL-PA4010 via Ethernet cable to the main Deco or satellite Deco;
- Copy Link
- Report Inappropriate Content
Many thanks
Have done that , am seeing different / slower speeds to the AV600 after setting up the M5, can the M5 set up interfere with the AV600 plug in set up. Seeing a situation where I have decent wifi upstairs but furthest away room has slow speeds at the ethernet cable
Thanks
- Copy Link
- Report Inappropriate Content
Hi, normally setting up the Deco M5 would not affect the speed of the powerline kit;
If you have the powerline utility installed, you could check the current powerline rate between the AV600 kit in case it is caused by the powerline interference around;
Thanks.
- Copy Link
- Report Inappropriate Content
Many thanks, all sorted, reset all and started again, have identified an issue with a plug socket in one room but AV600 working well in a different socket, alongside M5 set up
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 713
Replies: 4
Voters 0
No one has voted for it yet.