@Charlie555 

 

I have seen this in my Deco app for devices that are connected to Deco by Ethernet cable. For wired devices this is expected - they don't roam between Deco units and "Mesh" has no meaning for them.

Thank you for your reply. The main deco is connected to my router by Ethernet but the 4 other units are not.

@Charlie555 

 

Here is an example from my home network.

 

 

There are two devices connected to my Office Deco: Water Heater by WiFi and Xerox printer by Ethernet cable. Water Heater has Mesh button, Xerox printer does not.

 

When I open Xerox printer info page in Deco app I see the following:

 

 

 

It says Connection Type: Wired. This is expected. That device will not have Mesh button.

 

You may wish to share screenshots of wireless clients (Connection Type: Main Network or Connection Type: Guest Network) without Mesh button.

 

 

@Alexandre. 
 

here are 2 screenshots - mesh not shown on deco or the mesh button for my iPhone 

@TP-Link 

 

hi

this happened after a firmware update I think. 

 

I have 4 deco units, they all show 'mesh' or they don't show anything. 
 

Mostly they don't show anything- mesh only appears sometimes. I only know when I check the APP. 

will do as you ask on the log

If I reboot the main deco, ‘mesh’ reappears in the APP on all the Deco’s where there are connected clients. However if I close the APP and reopen it later the mesh bit has disappeared on them all again. I think it may be an APP issue , I downloaded the updated version only a few days ago on 20 July