DECO E4 IS STUCK ON YELLOW
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
one of the units of the mesh system is stuck on yellow light for some reason, i had even tried the firmware recovery fix but it just doesn't seem to work. any solutions? I had purchssed the 3 pack one about a month ago.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@RM001 I had also tried resetting and changing power cords but it still doesn't seem to work
- Copy Link
- Report Inappropriate Content
Hi,
Is there any change recently, like a firmware upgrade, power outage?
Please also refer to this link to do a firmware recovery;
https://www.tp-link.com/support/faq/2958/
Thank you.
- Copy Link
- Report Inappropriate Content
@TP-Link there wasn't any firmware upgrade, yes that's the same link I used for the firmware recovery and it showed it was successful, and still the same issue persists.
- Copy Link
- Report Inappropriate Content
In this way, I think you could contact the local warranty office to ask for the warranty.
Thank you very much.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 776
Replies: 4
Voters 0
No one has voted for it yet.