DECO M5 - Constant yellow light on after firmware upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

DECO M5 - Constant yellow light on after firmware upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
DECO M5 - Constant yellow light on after firmware upgrade
DECO M5 - Constant yellow light on after firmware upgrade
2021-08-08 08:18:16
Model: Deco M5  
Hardware Version: V1
Firmware Version: V1_1.5.3_20210203

I have a setup of 3 units (Deco M5). One of them (not the main) has stopped working after upgrade.
Yellow led is constant.
1). Hard reset doesn't help. Causes the unit to start blinking blue/green for a short time and then going back to Yellow. If you power on/off it turns to red.
2). Tried reinstalling firmware to the unit using TFTP. The code is uploaded , but after the process (2 minutes or so) - the unit goes back to constant Yellow.
3). Tried loading previous firmware code to the unit - same result.
Can this unit be 'saved'?

Thanks

  0      
  0      
#1
Options
1 Reply
Re:DECO M5 - Constant yellow light on after firmware upgrade
2021-08-09 03:22:14

@VansoverShay 

Thank you very much for the feedback.

Since neither reset nor firmware recovery helped,  I am afraid that you might need to contact the local shop retailer to check for the warranty service.

 

 

  0  
  0  
#2
Options