DHCP MER Option 61 - 60
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi All,
Does anyone know if this supports Skys MER Option 60/61?
Can't seem to find it in the ISP drop down.
Thanks
Pete
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
The Archer AX90 doesn't support Sky MER DHCP option 60/61, we only have the DSL modem routers can work with that, such as Archer VR2100.
- Copy Link
- Report Inappropriate Content
The Archer AX90 doesn't support Sky MER DHCP option 60/61, we only have the DSL modem routers can work with that, such as Archer VR2100.
- Copy Link
- Report Inappropriate Content
I thought that was the case.
I have FTTP with a Openreach ONT, So from what I am aware I should be able to connect via IPv6 but I cant seem to get it to work.
These are the settings I have found below,
Select the WAN interface section of router GUI, then select dual-stack option WAN interface for IPv4 & IPv6, for the address select DHCPv6 (dynamic option not static), enable prefix delegation (PD) on WAN and then select SLACC for IPv6 creation method on LAN interface is how I see it in the manual.
Can this be done with what i have?
- Copy Link
- Report Inappropriate Content
Kindly refer to the below guide to configure the IPv6 on the router again:
https://www.tp-link.com/support/faq/1525/
If the connection still fails, please confirm again if the IPv6 type is Dynamic or PPPoE with your ISP. BTW, who is your ISP?
What is your network topology, is it ISP modem--AX90? Is the IPv4 connection on the router good or not? What is the WAN IP address of it?
You may check if GS-Link's settings will help your case:
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3071
Replies: 3
Voters 0
No one has voted for it yet.