Home Network Community > Wi-Fi Routers > Help!!Firmware update has nerfed my internet speeds
< Wi-Fi Routers

Help!!Firmware update has nerfed my internet speeds

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Help!!Firmware update has nerfed my internet speeds

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Help!!Firmware update has nerfed my internet speeds
Help!!Firmware update has nerfed my internet speeds
2021-08-16 10:21:43
Model: Archer AX10  
Hardware Version: V2
Firmware Version: 1.2.0 Build 20210421

Model: Archer AX10 (US) V1.2

 

Problem: I have a 200 Mbps connection but after I installed a firmware update I get speeds only up to 100 Mbps

The auto-negotiation feature doesn't go to 1000 Mbps full-duplex after update (only till 100 Mbps)

I manually set it to 1000mbps full-duplex but after saving I lose internet connection, the internet light starts flashing orange after every 5 seconds or so.

So I have to reset back to auto-negotiation.

 

I already tried resetting the router, it did not help,

I went to the support site and tried to downgrade the firmware it does not downgrade.

 

Please Help

  0      
 
  0      
 
#1
Options
3 Reply
Re:Help!!Firmware update has nerfed my internet speeds
2021-08-16 10:59:46

@ashton1502 

 

Have you tried to change the ethernet cable with a new one (CAT 5E/6) or the port of the device to which the AX10 WAN port is connected ?

 

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options
Re:Help!!Firmware update has nerfed my internet speeds
2021-08-16 11:07:56

@terziyski thank you for your reply!

I don't think the problem is with my cat 6 cable because it worked perfectly fine before the update giving me speeds up to 200 Mbps. the cable is not even 6 months old at this point. and I tried connecting it directly to my pc. I am getting 200 mbps speed.

 

Additional Note: The router is connected to the internet through an ont router. So a cat cable from my main router's LAN port to tp link's wan port, extending my wifi range.

  0  
  0  
#3
Options
Re:Help!!Firmware update has nerfed my internet speeds
2021-08-16 11:44:17

@ashton1502 

 

If there is additional cable, it's suggested to have a try as suggested by terziyski just in case the new firmware is pickier for the cable quality.

 

At the same time, we will report the issue to the support engineers, we will confirm if there is a way to downgrade the firmware to the previous version.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 696

Replies: 3

Related Articles
help ! No internet
80 0
Update or help needed
123 1
Can't seem up update Archer C7 firmware, would appreciate some help :)
1474 0
Internet speed
52 0
Need Help in internet problem
464 0
Deco M9 - Slow Speed Help
1155 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.