CLI VR2600
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CLI VR2600
Hello,
where can I found manpage and more for CLI Archer VR2600.
First I will close all open ports (ssh... ) to internet. It was surprise that i can connect to Webinterface over Internet.
Thanks
Re:CLI VR2600
To be able to access WebGUI of the device through Internet you need to have remote management enabled:
The other way device to be managed from outside your network is through CWMP, configured by your ISP:
To open ports for accessing services through Interenet, you should have configured virtual servers :
or DMZ:
And finally if you have UPnP on the device enabled and there are any services in the table:
If you haven't enabled these you shouldn't have access to the WebGUI or services from outside your network.
If this was helpful click on the arrow pointing upward to make it blue.
If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
