Home Network Community > Wi-Fi Routers > Archer C60 brick
< Wi-Fi Routers

Archer C60 brick

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C60 brick

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C60 brick
Archer C60 brick
2021-10-06 09:02:31 - last edited 2021-10-06 09:09:11
Model: Adapter  
Hardware Version: V1
Firmware Version: 
Hello, I'm Spanish, and my English is bad, excuse me.

 

I have an archer C60, when updating I had a power failure and now it only turns on the power light. 
I am using kali linux and I have the ip 192.168.0.66 as I have seen in some forums, I try to load the firmware by tft with putty having previously named tp_recovery.bin, but at the time of loading the firmware it gives me.

ARP Retry count exceeded; stating again
TX Timed out
  1      
 
  1      
 
#1
Options
4 Reply
Re:Archer C60 brick
2021-10-06 12:11:26

@black0rag 

 

Check this thread solution suggestions.

You can read through this thread as well to see if that will help.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  1  
  1  
#2
Options
Re:Archer C60 brick
2021-10-06 14:28:01 - last edited 2021-10-06 15:18:19

@terziyski 

 

Thanks for your answer, and tested by tftp with the uart cable I think it is called and it gives me the following answer.

 

Trying eth0
eth0 link down
FAIL
Trying eth1
enet1 port3 up
dup 1 speed 1000
Using eth1 device
TFTP from server 192.168.0.66; our IP address is 192.168.0.86
Filename 'tp_recovery.bin'.
Load address: 0x80800000
Loading: T T ## Booting image at 9f020000 ...
Bad Magic Number

Retry count exceeded; starting again

 

  0  
  0  
#3
Options
Re:Archer C60 brick
2021-10-06 16:53:52

@black0rag 

 

Similar issue here.

You can check up a thread from OpenWRT forum regarding this message here.

I really don't know how to advise further.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#4
Options
Re:Archer C60 brick
2021-10-19 15:10:32

@black0rag faced the same issue. tried through TFTP recovery. But the router needs to reset in order to flash the firmware.But even after holding the reset button for more than 30 seconds the router did not reset and all leds kept glowing.Let me know if you find any solution. 

  0  
  0  
#5
Options

Information

Helpful: 1

Views: 1139

Replies: 4

Related Articles
 Archer c60 brick update
513 0
 Archer c60 brick
1874 0
 Archer C60 brick after flashing a firmware
4177 0
Archer C60 problems
1031 0
Archer C60 Cloud
1291 1
 Archer 3200 Brick
498 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.