Home Network Community > 3G/4G Routers/MiFi > 4G Router TL-MR100 cannot access admin page on 192.168.1.1
< 3G/4G Routers/MiFi

4G Router TL-MR100 cannot access admin page on 192.168.1.1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

4G Router TL-MR100 cannot access admin page on 192.168.1.1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
4G Router TL-MR100 cannot access admin page on 192.168.1.1
4G Router TL-MR100 cannot access admin page on 192.168.1.1
2021-11-13 12:10:17
Model: TL-MR100  
Hardware Version: V1
Firmware Version:


My 4G Router TL-MR100 has suddenly stopped working properly. If I connect to the WiFi network it creates, I have no internet access (the corresponding light on the router is off).
I connected the router with an Ethernet cable to a computer, but I cannot access the admin page at 192.168.1.1 : nothing loads at all. I tried three different computers (two Windows 10 systems and one Linux) and several browsers (Chrome, Edge, Internet Explorer) and the result is always the same (cannot access the page).
If I open a command prompt and I do 

ping 192.168.1.1

I do get reply from the router.
What can I do?

  0      
 
  0      
 
#1
Options
2 Reply
Re:4G Router TL-MR100 cannot access admin page on 192.168.1.1
2021-11-13 14:34:26

@Lorenzo1234 

 

Hi,

 

If a normal reset (power off -> power on) doesn't bring the router back to life, then try do perform a reset to factory defaults, which is usually done by having the router powered on and pressing and holding the reset button for > 5 seconds. (or keep the button pressed until you notice some sort of feedback from the router's LEDs)

 

In case even a factory reset doesn't help to get the router back working again, then I am afraid the router might actually have experienced some hardware failure during operation, which happens very seldom nowadays, but is not unheard of. 

 

  1  
  1  
#2
Options
Re:4G Router TL-MR100 cannot access admin page on 192.168.1.1
2021-11-21 23:23:01
Hi, thank you very much for you answer. I tried a factory reset, but it didn't change anything... at the end, fortunately, I could give the router back to the retailer (I bought it only about 6 months ago) and I bought a new one, which worked flawlessly. As far as I can tell it must have been a hardware failure.
  2  
  2  
#3
Options

Information

Helpful: 0

Views: 1968

Replies: 2

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.