Bonjour protocole through AX50
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bonjour,
je voudrais savoir comment router le protocole Bonjour (zeroconf) a travers le AX50 ?
Mon réseau principal est en 192.168.1,x, celui fourni en wifi est 192.168.0.x, je ne vois pas les imprimantes ou serveurs qui se trouvent sur le reseau local depuis le wifi et vice-versa.
Merci.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello, as far as I can confirm, the router will not block any mDNS traffic in the network. Can I have a detailed network layout of the network? How are the routers connected to the network?
There are cases we may need to configure static routing on the router, you can check which case you are in:
- Copy Link
- Report Inappropriate Content
hi,
the network is basic, a FAI box with NAT, so lan printer and server are on 192.168.1.x.
The AX55 is 192.168.1.100 wan side and 192.168.0.x for wifi connected products.
Wifi stuff on 192.168.0.x doesn't see bonjour printer or server.
i let the AX55 in router mode because i need parental controls.
Best regards
Gerard
- Copy Link
- Report Inappropriate Content
Hello Gerard, you need to either change the FAI box into bridge mode or change the AX50 into AP mode if you want all the client devices communicate with each other.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
If that is the case, I guess you will need to connect those servers or printers to the AX50 directly, as the mDNS traffic can only be transferred within a single IP subnet.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 745
Replies: 5
Voters 0
No one has voted for it yet.