VR400 Takes forever to reconnect

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

VR400 Takes forever to reconnect

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VR400 Takes forever to reconnect
VR400 Takes forever to reconnect
2021-12-10 09:47:16
Model: Archer VR400  
Hardware Version: V2
Firmware Version: Firmware Version:0.5.0 0.9.1 v0070.0 Build 200716 Rel.53516n

I've had this for a while, not the usual brand i buy. the experience has been mixed but mostly good. 
However, my VDSL service is in the lower end of speeds available 30mbps, When the router loses connection, even from changing settings it takes a good 3-5 minutes before it starts trying to get a sync. 
Annoyingly, it also starts at the highest sync rate and works its way down, which would be fine if i was using it in another location however i'm not. 
The line speed, will always be that line speed.
SO

Why can't TP link

 

1. Speed up the reconnection process

2. Allow the user to set their own maximum sync rate so that the modem doesn't waste time trying to sync a 30mpbs service at 100mpbs

  0      
  0      
#1
Options